Error code · Water Heater

GE GeoSpring First-Generation GEH50DEED Code Dirty Filter (F14): Clean the filter

Low risk · DIY check OK

Code: Dirty Filter (F14)
Appliance: Water Heater
Brand: GE
Warranty: 30-day workmanship

What Dirty Filter (F14) means

On the first-generation GE GeoSpring GEH50DEED hybrid water heater, built roughly 2009 to 2012, Dirty Filter, shown as F14, tells you the air filter is dirty. The heat pump pulls room air through the filter, and a loaded filter cuts the airflow that the unit relies on. This is a maintenance reminder, not a failure of a part. It is the one message on this generation that you can usually clear yourself.

Common causes of Dirty Filter (F14)

How much lint and dust has collected on the filter
Whether the filter sits properly in its frame
Airflow around the inlet and outlet
The control's filter reminder logic

✓ One safe check you can try

1. Remove and clean the filter as the owner's manual describes. 2. Refit it fully so it sits properly in its frame. 3. Move any boxes or stored items away from the unit. 4. If the message returns soon after, call us.

! Why to stop there

If the message returns right after cleaning, the airflow path or the reminder logic needs inspecting.
We check the airflow, fan and filter fit.
Fan speed and filter fit are verified, since either can mimic a dirty filter.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Water Heater codes

bAd linE (F12)GE GeoSpring First-Generation GEH50DEED Code bAd linE (F12): Supply voltage low F13GE GeoSpring First-Generation GEH50DEED Code F13: Keypad key stuck F15GE GeoSpring First-Generation GEH50DEED Code F15: DataFlash memory error Attention! Tank not filled!GE GeoSpring GEH50DNSRSA Message "Attention! Tank not filled!": Fill before power Heat Pump FailureGE GeoSpring GEH50DXSRGA Message "Heat Pump Failure": Heat pump section problem Water Heater FailureGE GeoSpring GEH50DNSRSA Message "Water Heater Failure": Electric side problem System FailureGE GeoSpring GEH50DXSRGA Message "System Failure": Immediate attention Wiring to unit incorrectGE GeoSpring GEH50DNSRSA Message "Wiring to unit incorrect. Must be 240V not 120V": Supply check

Dirty Filter (F14)Dirty Filter (F14) questions

How do I clean the filter?

Follow the owner's manual page for the filter. Generally it comes out, gets cleaned and dried, and goes back in fully seated so air cannot bypass it.

Will the message clear itself?

It should after cleaning. If it does not, tell us what the display shows, because a message that stays after a clean filter points to something else.

Does a dirty filter cost me money?

Yes, a loaded filter makes the heat pump work harder and use more energy. Cleaning it is free and takes only a few minutes, so do it before calling.

Book a visit

Still unsure about Dirty Filter (F14)?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545