Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent GE specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 547-5545 Arrange a Repair
Error code · Water Heater

GE GeoSpring Code F81: leak sensor battery low

On GE Profile GeoSpring hybrid heat pump water heaters made from June 2025, such as the GEH50DEEJSC, F81 means the leak sensor battery is low. The sensor runs on a battery so it can watch for…

Low risk · DIY check OK
Arrange a Repair(713) 547-5545
Code
F81
Appliance
Water Heater
Brand
GE
Warranty
30-day workmanship

What F81 means

On GE Profile GeoSpring hybrid heat pump water heaters made from June 2025, such as the GEH50DEEJSC, F81 means the leak sensor battery is low. The sensor runs on a battery so it can watch for water even during a power loss. When the battery weakens, the control warns you so the sensor keeps working. Your hot water is not affected by this message.

Common causes of F81

  • Leak sensor battery worn out
  • Battery installed incorrectly
  • Sensor connection loose
✓ One safe check you can try

1. Find the leak sensor battery, using the owner's manual to see where it sits. 2. Replace it with a fresh battery of the type the manual lists. 3. Install it with the correct polarity and seat the cover. 4. Check the display and confirm F81 is gone. 5. If F81 stays, call us.

! Why to stop there
  • A new battery with F81 still showing points to the sensor.
  • We test the sensor and its connection.
  • Leak protection should be working, so we do not leave it undone.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Water Heater codes

Attention! Tank not filled!GE GeoSpring GEH50DNSRSA Message "Attention! Tank not filled!": Fill before power Heat Pump FailureGE GeoSpring GEH50DXSRGA Message "Heat Pump Failure": Heat pump section problem Water Heater FailureGE GeoSpring GEH50DNSRSA Message "Water Heater Failure": Electric side problem System FailureGE GeoSpring GEH50DXSRGA Message "System Failure": Immediate attention Wiring to unit incorrectGE GeoSpring GEH50DNSRSA Message "Wiring to unit incorrect. Must be 240V not 120V": Supply check EPGE GeoSpring GEH50DXSRGA Code EP: Energy price signal F5, F6, F7, F8GE GeoSpring First-Generation GEH50DEED Codes F5-F8: Sensor failures F9GE GeoSpring First-Generation GEH50DEED Code F9: Bottom element problem
F81F81 questions
Does F81 affect my hot water?

No. It only warns that the leak sensor battery is low. Your water heating continues normally, but the leak sensor may stop warning you about water, so replace the battery soon.

What battery do I need?

The owner's manual lists the battery type and shows where it sits. Use a fresh battery and install it with the correct polarity so that the sensor starts reporting again.

F81 stays after a new battery. Why?

The sensor itself or its connection may need checking. We test the sensor and give you a written price before any repair, and our work carries a 30-day workmanship warranty.

Book a visit

Still unsure about F81?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545