Error code · Room Air Conditioner

GE Built-In AC Code HS: Electric Heat Sensor Error

Medium · inspection needed

Code: HS
Appliance: Room Air Conditioner
Brand: GE
Warranty: 30-day workmanship

What HS means

On GE built-in room air conditioners with electric heat in the AJCQ and AKCQ series, HS means an electric heating sensor error. The control cannot read the temperature of the heating section reliably, so it may stop heating to stay safe. Full model numbers include the AJCQ10ACH and the AKCQ10ACJ. Cooling may still run, because HS concerns the heating side. HS appears on the display.

Common causes of HS

Electric heat sensor reading outside the expected range
Sensor connection at the control
Heating section not getting enough airflow

✓ One safe check you can try

1. Unplug the unit, then plug it back in. 2. Make sure the air filter is clean and the grille is not blocked. 3. If HS repeats, leave the heat off and call for service. 4. Use cooling or fan only until it has been checked.

! Why to stop there

Whether the sensor, its wiring or the control is the cause stays unknown from the display
We test the sensor and the airflow across the heating section, then quote the repair in writing

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Room Air Conditioner codes

Temperature display flashingGE Zoneline AZ41 AZ61 Temperature Display Flashing: Unit Alert 25GE Zoneline AZ95 Code 25: Defrost lockout for 4.5 days 15GE Zoneline AZ90 Code 15: Heat Pump Coil Colder Than Ambient 88GE AC Display Shows 88 on Power-Up: Normal Display Test 26GE Zoneline AZ95 Code 26: No cooling while it is cold outside 16GE Zoneline AZ90 Code 16: Temperature Beyond Operating Limits 31GE Zoneline AZ95 Code 31: Lost contact with the 2-way thermostat 17GE Zoneline AZ90 Code 17: Minimum Configuration Not Met

HSHS questions

What does HS mean on my GE built-in AC?

It means an electric heating sensor error. The control cannot trust the temperature reading from the heating section, so it may shut heating down to protect the unit.

Can I still use cooling with HS showing?

Often yes, since HS concerns the heating side. But if the unit acts oddly in any mode, leave it off until it has been checked, and tell us which modes still run.

Should I try the electric heat again after HS?

You can unplug and restart once. If HS comes back, stop using the heat so the heating section is not run without a trustworthy reading, and call us to test it.

Book a visit

Still seeing HS?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545