GE Profile Opal 2.0 Add Water: Reservoir needs filling
On the GE Profile Opal 2.0 and 2.0 Ultra nugget ice makers (XPIO13, XPIO23 and XPIO43, with the indicator-light panel), the Add Water light highlights when the unit needs more water before it can cycle to…
- Code
- Add Water
- Appliance
- Opal Ice Maker
- Brand
- GE
- Warranty
- 30-day workmanship
What Add Water means
On the GE Profile Opal 2.0 and 2.0 Ultra nugget ice makers (XPIO13, XPIO23 and XPIO43, with the indicator-light panel), the Add Water light highlights when the unit needs more water before it can cycle to make ice or to clean. It is a plain reminder about the reservoir level. The machine pauses until it has enough water, so no ice is produced while the light is on.
Common causes of Add Water
- Reservoir below the minimum level
- Water used up by ice making
- Reservoir not seated correctly after filling
1. Fill the reservoir to the Max Fill line. 2. Seat the reservoir properly. 3. Wait a moment for the light to clear. 4. Do not overfill past the line. Wait for the light to go out before expecting new ice.
- If the reservoir is full and Add Water stays lit, the water level sensing needs testing.
- We check the sensor and the pump path.
- A written price comes first.
Other Opal Ice Maker codes
Why is Add Water lit on my Opal?
The unit needs more water before it can make ice or run a cleaning cycle. Fill it to the Max Fill line. It tells you that the unit is waiting for water.
I filled it and the light is still on. What now?
Check the reservoir is seated fully and not overfilled. If the light stays, the water level sensing needs testing. The Max Fill line is the guide; fill to it and no higher.
Does it stop making ice?
Yes, until there is enough water. Filling the reservoir lets it resume. A reservoir that is not pushed fully into place can also trigger this, so press it firmly into position and check again.
Still unsure about Add Water?
A technician diagnoses it on site and gives you the price in writing before any work starts.