Error code · Dryer

GE Ventless Dryer Empty Tank Light: Water Tank Is Full and the Cycle Is Paused

Low risk · DIY check OK

Code: Empty Tank
Appliance: Dryer
Brand: GE
Warranty: 30-day workmanship

What Empty Tank means

On the GE 24-inch ventless condenser dryer GFT14, such as the GFT14ESSMWW, the Empty Tank light means the tank that collects the water pulled from your clothes is full. The dryer will not operate until the tank is emptied and the indicator is cleared. If the tank overfills during a cycle, the cycle stops. You see the light on, the drum idle and the clothes still damp.

Common causes of Empty Tank

Condensate tank full
Tank not seated fully after emptying
Drain hose not connected if you use the drain hose option

✓ One safe check you can try

1. Pull out the water tank and carry it level to a sink. 2. Empty it and slide it back in until it seats. 3. Press Start. The light turns off and the cycle resumes. 4. If you would rather skip emptying, install the drain hose so water leaves on its own.

! Why to stop there

If the tank is empty and seated but the light stays on, we check the level sensing circuit for the tank.
A drain hose that is installed but kinked can also back water up into the tank, and we trace it.
You get a written price before any work, and the repair carries a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

Check VentGE Dryer Check Vent Light: Airflow Is Reduced, Vent May Be Restricted Vent BlockedGE Profile Dryer Vent Blocked Light: Restricted Airflow Warning 01 / 02 / 03GE Profile Dryer Vent Health Result 01, 02 or 03: How Restricted Is the Vent 00GE Profile Dryer Vent Health Result 00: Test Invalid, Room Too Warm Clean Lint FilterGE Dryer Clean Lint Filter Light: Reminder Before the Next Load Tank Low / EmptyGE Profile Dryer Fabric Refresh Tank Low or Empty: Refill Before the Next Cycle 1 / 2GE Dryer Display "1" or "2": Choose Electric or Gas Setting

Empty TankEmpty Tank questions

How often will I need to empty the GFT14 tank?

The tank fills as the dryer removes water from your loads, so heavy loads fill it faster. Empty it after each load or whenever the light comes on. A drain hose removes the chore.

Why did the cycle stop mid-load?

Overfilling the tank stops the cycle so water cannot spill. Empty the tank, seat it, and press Start. The light clears and the cycle picks up where it paused.

Does a ventless dryer still need cleaning?

Yes. The lint filter and the condenser area still collect lint, and a clean path helps the dryer remove water faster. Check the filter after every load.

Book a visit

Still unsure about Empty Tank?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545