Error code · Water Heater

GE GeoSpring PF/PH Code F60: Incoming Power Check Did Not Pass

High · stop use, call now

Code: F60
Appliance: Water Heater
Brand: GE
Warranty: 30-day workmanship

What F60 means

On 2025-and-newer GE Profile GeoSpring PF and PH heat pump water heaters, F60 is an AC detection failure. The control checks the incoming power to confirm it is wired the way the unit expects, and F60 shows when that check does not pass. Most often this is seen on a new installation or after electrical work, with a heater that does not start heating or shuts down right after power-up. It points toward the wiring supplying the unit.

Common causes of F60

Supply wiring not matching what the unit expects
Loose or missing neutral or ground connection
Breaker or disconnect problem
AC sensing circuit on the control

✓ One safe check you can try

1. See which code the display shows and find the model number on the rating label. 2. If the heater was just installed or electrical work was done recently, tell us who did it and when. 3. Switch the breaker off and leave it off. 4. Do not open the wiring compartment. Call us to confirm the wiring is correct.

! Why to stop there

The code is about the incoming power, so we start with the supply and the connections.
We confirm the wiring before suspecting the control.
Anything we find is explained and priced in writing first.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Water Heater codes

Attention! Tank not filled!GE GeoSpring GEH50DNSRSA Message "Attention! Tank not filled!": Fill before power Heat Pump FailureGE GeoSpring GEH50DXSRGA Message "Heat Pump Failure": Heat pump section problem Water Heater FailureGE GeoSpring GEH50DNSRSA Message "Water Heater Failure": Electric side problem System FailureGE GeoSpring GEH50DXSRGA Message "System Failure": Immediate attention Wiring to unit incorrectGE GeoSpring GEH50DNSRSA Message "Wiring to unit incorrect. Must be 240V not 120V": Supply check EPGE GeoSpring GEH50DXSRGA Code EP: Energy price signal F5, F6, F7, F8GE GeoSpring First-Generation GEH50DEED Codes F5-F8: Sensor failures F9GE GeoSpring First-Generation GEH50DEED Code F9: Bottom element problem

F60F60 questions

Why does F60 often appear after installation?

The control checks how it is wired as soon as it gets power. If a connection was made incorrectly, the check fails and the code appears right away.

Can I just flip the breaker again?

Please do not keep cycling it. If the wiring is wrong, repeated power-ups do not help and can be unsafe. Leave it off until we have checked.

Does this involve my house wiring?

It can. We look at the connections at the unit and at the disconnect, and we tell you plainly if anything outside the heater needs an electrician.

Book a visit

Still seeing F60?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545