Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent GE specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 547-5545 Arrange a Repair
Error code · Dishwasher

GE Dishwasher Low Rinse Aid Indicator: Refill the Dispenser

On GE and GE Profile dishwashers from 2012 to 2018, such as the GDT695, PDT750 and GDF570, the Low Rinse Aid indicator means the rinse agent is low or empty. It is a maintenance indicator, not…

Low risk · DIY check OK
Arrange a Repair(713) 547-5545
Code
Low Rinse Aid
Appliance
Dishwasher
Brand
GE
Warranty
30-day workmanship

What Low Rinse Aid means

On GE and GE Profile dishwashers from 2012 to 2018, such as the GDT695, PDT750 and GDF570, the Low Rinse Aid indicator means the rinse agent is low or empty. It is a maintenance indicator, not a problem with the dishwasher. Without rinse aid, dishes may dry less well and show spots, but the wash still runs. You see the indicator lit on the control panel.

Common causes of Low Rinse Aid

  • Rinse aid dispenser low or empty
  • Indicator setting turned on
✓ One safe check you can try

1. Open the rinse aid dispenser cap inside the door. 2. Refill it with rinse aid. 3. Close the cap firmly. 4. If you prefer not to use rinse aid, press Pre-Soak or Steam 7 times within 5 seconds to turn the indicator off or back on.

! Why to stop there
  • If the dispenser is full and the indicator stays on, we check the sensing for the rinse aid level.
  • A dispenser that leaks or does not release rinse aid is a separate matter we can look at.
  • The price is written before any work, with a 30-day workmanship warranty.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Dishwasher codes

Smart Assist light redGE Dishwasher Smart Assist Light Red: A Potential Problem Was Detected Smart Assist light yellowGE Dishwasher Smart Assist Light Yellow: A Notification Is Waiting in SmartHQ Start light flashingGE Dishwasher Start Light Flashing: Door Opened or Cycle Interrupted 999GE Dishwasher Code 999: Possible Leak, or a Control Reset PrSGE Electronic Dishwasher Code PrS: Sensor for Water Pressure Sends Invalid Signal C1GE Electronic Dishwasher Code C1: Drain Step Ran Past 2 Minutes C2GE Dishwasher Code C2: Total Draining Time Beyond 7 Minutes C3GE Electronic Dishwasher Code C3: Tub Will Not Drain at All
Low Rinse AidLow Rinse Aid questions
Can I turn off the Low Rinse Aid indicator?

Yes. Press Pre-Soak or Steam 7 times within 5 seconds to turn it off or on again. Do this only if you do not plan to use rinse aid, otherwise you lose the reminder.

Does an empty dispenser stop the dishwasher?

No. The wash still runs, but dishes may not dry as well and can show water spots. Refilling the dispenser usually brings the drying back to normal.

How much rinse aid does the dispenser hold?

Fill it to the level mark inside the dispenser, without overfilling. Too much can leave streaks or foam, and any spill should be wiped up.

Book a visit

Still unsure about Low Rinse Aid?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545