Error code · Range

GE Range Message “LOCK DOOR”: Self-Clean Door Not Closed

Low risk · DIY check OK

Code: LOCK DOOR / DOOR LOCKING
Appliance: Range
Brand: GE
Warranty: 30-day workmanship

What LOCK DOOR / DOOR LOCKING means

On GE, GE Profile and Café electric, gas and induction ranges with self-clean (2012 and newer, electronic controls), LOCK DOOR, DOOR LOCKING, DOOR LOCK or LOCKED flashes in the display when the self-clean cycle has been selected but the oven door is not closed. The wording varies by model. Models include the JB735SPSS, JB645RKSS, JGB735SPSS, PGS930SELSS and PHS930SLSS. It is not the control lockout, which is a different message.

Common causes of LOCK DOOR / DOOR LOCKING

Oven door not fully closed
Manual latch not set on latch models
Door lock motor or latch not engaging
Door switch not registering closed

✓ One safe check you can try

1. Close the oven door fully. 2. On manual-latch models, slide the latch over. 3. Check that nothing is blocking the door gasket. 4. Start self-clean again. 5. On a gas range, if you smell gas at any point, leave the house and call the gas utility from outside.

! Why to stop there

If the door is closed and the message continues, whether the lock motor or the door switch is to blame stays unknown
We test the latch and the switch, then give you the repair price in writing

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

Optimizing Cook TimeGE Range Message "Optimizing Cook Time": Voltage Check at Cycle Start SALE / Demo modeGE Range Display Shows SALE: Demo Mode From 120-Volt Power Wi-Fi icon flashing / solidGE Smart Range Wi-Fi Icon Flashing or Solid: Setup Connection Status Cooktop Hot / Hot SurfaceGE Electric Range Hot Surface Indicator: Glass Cooktop Still Warm Control panel flashingGE Gas Range Control Panel Flashing After Lockout: Burner Knobs Left On DOOR LOCKEDGE Range Message "DOOR LOCKED": Oven Still Hot HOTGE Profile Range Message "HOT": Steam Clean Will Not Start F + number or letterGE Range Code F: Function Error Code Hub

LOCK DOOR / DOOR LOCKINGLOCK DOOR / DOOR LOCKING questions

Why does my oven flash LOCK DOOR when I start self-clean?

The cycle is selected but the door is not closed. Close it fully, and set the latch on manual-latch models, then start the cycle again. The flashing stops once the door registers closed.

Is this the same as the control lock message?

No. The control lockout locks the pads on the panel, while LOCK DOOR is about the oven door and the self-clean cycle. Closing the door is the only thing that clears it.

What if the door is shut and it still flashes?

Then the lock or the door switch may not be registering the closed door. We check both and give a written price before any repair.

Book a visit

Still unsure about LOCK DOOR / DOOR LOCKING?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545