Error code · Washer

GE UltraFresh Washer Code 29: Drive Board Self-Check Failed

High · stop use, call now

Code: 29
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What 29 means

On GE UltraFresh front-load washers (the GFW510, GFW550, GFW650 and GFW850 series, 2020 and newer), code 29 means the motor-drive processor failed its continuous self-check, which tests its memory, registers and clock. When the drive cannot trust itself, the control stops the motor. Only a technician reading the stored error history, or the display on these models, will show you the number itself. Owners usually see a washer that will not spin the drum, stops mid-cycle or will not start.

Common causes of 29

Motor drive board electronics
Connectors and wiring between the drive and main board
Power quality reaching the washer
Main control communication with the drive

✓ One safe check you can try

1. Note the cycle you were on and whether the washer lost power or stopped suddenly. 2. Check that the plug is fully seated and the outlet works, such as with another small appliance. 3. Do not open the back or base panels; the drive is not an owner repair.

! Why to stop there

A self-check failure points to the drive electronics, but a poor connection or supply issue can imitate it
We check the power at the outlet and the connections before deciding on the drive
You see a written price before we replace any board, and repairs have a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Fill light blinkingGE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid Wash and Rinse lights blinkingGE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub CLrFLtrGE Compact Washer Message "CLrFLtr": Drain Pump Filter Needs Cleaning Load RebalancingGE Front-Load Washer Message "Load Rebalancing": Washer Is Correcting an Uneven Load A problem has been detectedGE Profile Harmony Washer Message "A problem has been detected with this unit": Electronics Alert

2929 questions

Is code 29 a problem with my clothes?

No. It concerns the electronics that run the motor, not the load, so changing the laundry will not help. That is why we check the outlet and connections first and only then look at the drive electronics.

Could a power dip trigger it?

Possibly, so we check supply and connections first, then the board. The drive board controls only the motor, so the control panel may still light up even while the drum will not turn.

What does the drive board do?

It controls how the motor starts, turns and stops. If it cannot trust its own memory or clock, the control shuts the motor down for safety.

Book a visit

Still seeing 29?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545