Error code · Washer

GE Front-Load Washer Message “Load Rebalancing”: Washer Is Correcting an Uneven Load

Low risk · DIY check OK

Code: Load Rebalancing
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What Load Rebalancing means

On GE front-load washers from 2017 and 2018, the GFW450 family such as the GFW450SSMWW, Load Rebalancing is an information message. It tells you the washer detected an out-of-balance condition and is taking actions on its own to correct it and finish the cycle. On some models the Spin light blinks along with it. You may hear the drum slow, tumble and try again, which adds time to the cycle.

Common causes of Load Rebalancing

Single heavy or bulky item bunched in the drum
Mixed load of heavy and light fabrics
Washer not standing level

✓ One safe check you can try

1. Let the cycle continue. The washer is working on it. 2. If clothes come out wetter than usual at the end, spread the load out evenly in the drum. 3. Run a Drain + Spin cycle. 4. Check that the washer does not rock when you press on a top corner.

! Why to stop there

If the message appears on every normal load, we check the leveling feet and how the washer sits on the floor.
We also look for wear in the drum suspension when imbalance keeps happening with mixed loads.
We quote the price in writing before work, and our repair has a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

85GE UltraFresh Washer Code 85: Voltage Out of Range Door / doorGE UltraFresh Washer Message "Door": Open the Door Before the Next Cycle LidGE Top-Load Washer Message "Lid": Open and Close the Lid to Continue Lid Locked light flashingGE Top-Load Washer Lid Locked Light Flashing: Three Cycles, No Lid Opened Fill light blinkingGE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid Wash and Rinse lights blinkingGE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water

Load RebalancingLoad Rebalancing questions

Does Load Rebalancing mean something is broken?

No. It is an information message that the washer is correcting an uneven load by itself. If the end of the cycle is fine, you do not need to do anything.

Why are my clothes wetter than usual after this message?

A cycle that had to rebalance may not reach full spin speed. Spread the clothes evenly and run Drain + Spin to get the water out of the load.

What loads cause it most?

A single towel, rug or comforter washed alone is the usual culprit. Adding a few similar items helps the drum keep the weight spread around the wall.

Book a visit

Still unsure about Load Rebalancing?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545