Error code · Washer

GE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid

Medium · inspection needed

Code: Fill light blinking
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What Fill light blinking means

On GE top-load washers without a text display, 2019 and newer (the GTW335, GTW465, GTW500 and GTW525), a blinking Fill light has two readings. Two blinks mean the washer did not sense water collecting in the tub during fill, so water is not entering. Three blinks mean water has sat in the washer 15 minutes with the lid open. The light can also flash after a pause longer than 24 hours or when the machine stopped itself. A 4-minute control lock-out follows while the pump runs. It is the no-display twin of H2O SUPPLY and CAnCELEd.

Common causes of Fill light blinking

Hot or cold supply valve partly closed
Kinked or clogged fill hose or inlet screen
Water inlet valve not delivering water to the tub
Lid left open during a long pause

✓ One safe check you can try

1. Count the blinks, two or three. 2. Confirm both the hot and cold supply valves behind the washer are fully on. 3. Wait out the 4-minute lock-out. Unplugging the washer restarts that timer, so leave it plugged in. 4. Close the lid and begin the cycle again. 5. If it blinks again, stop and let us check it.

! Why to stop there

With the valves open and hoses straight, repeated two-blink events lead us to the inlet screens and the water inlet valve, which we inspect.
Three blinks that return even with the lid handled correctly point us to the lid switch circuit.
We give you the price in writing first, and the repair has a 30-day workmanship warranty.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

85GE UltraFresh Washer Code 85: Voltage Out of Range Door / doorGE UltraFresh Washer Message "Door": Open the Door Before the Next Cycle LidGE Top-Load Washer Message "Lid": Open and Close the Lid to Continue Lid Locked light flashingGE Top-Load Washer Lid Locked Light Flashing: Three Cycles, No Lid Opened Wash and Rinse lights blinkingGE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub

Fill light blinkingFill light blinking questions

What is the difference between two blinks and three blinks?

Two blinks mean the washer did not see water arriving during fill. Three blinks mean water was left standing with the lid open for 15 minutes. The count tells us which direction to check first.

Why does the washer lock me out for 4 minutes?

After this event the control holds off for about four minutes while the pump runs. Unplugging restarts that timer, so waiting it out with the washer plugged in is quicker.

Is this the same as H2O SUPPLY on display models?

Yes. A Fill light flashing on a no-display washer corresponds to H2O SUPPLY on models that scroll text, so the first checks are the same: both supply valves and the hoses.

Book a visit

Still seeing Fill light blinking?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545