Error code · Dishwasher

GE Electronic Dishwasher Code C7: Temperature Sensor for the Wash Water, Not Responding

Medium · inspection needed

Code: C7
Appliance: Dishwasher
Brand: GE
Warranty: 30-day workmanship

What C7 means

On GE electronic dishwashers that display C-codes, such as the GDT530PSDSS, C7 means the water temperature sensor circuit is not working. The control uses this sensor to know whether the wash water is hot enough, and when the reading is missing or out of range it stops and shows C7. You will see the code and either a cycle that will not start or one that cancels. Because the circuit is involved, not just cold water, the supply temperature alone will not explain it.

Common causes of C7

Temperature sensor reading open or shorted
Wiring or connector to the sensor worn or loose
Control reading the sensor input incorrectly

✓ One safe check you can try

1. Turn off the dishwasher's circuit breaker for about 30 seconds. 2. Turn the breaker back on. 3. Close and latch the door firmly. 4. Start a short cycle and watch whether C7 returns. If it does, stop using the dishwasher and book a visit.

! Why to stop there

A reset cannot repair a sensor that has failed or a loose connection behind the tub.
We test the sensor circuit before replacing anything.
We give you a written price first.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

Smart Assist light redGE Dishwasher Smart Assist Light Red: A Potential Problem Was Detected Smart Assist light yellowGE Dishwasher Smart Assist Light Yellow: A Notification Is Waiting in SmartHQ Start light flashingGE Dishwasher Start Light Flashing: Door Opened or Cycle Interrupted Low Rinse AidGE Dishwasher Low Rinse Aid Indicator: Refill the Dispenser nH (Delay Start)GE Dishwasher Display nH: Delay Start Counting Down PFGE Dishwasher Code PF: Power Failure Noted by the Control PrSGE Electronic Dishwasher Code PrS: Sensor for Water Pressure Sends Invalid Signal 999GE Dishwasher Code 999: Possible Leak, or a Control Reset

C7C7 questions

What should I understand from C7 on a GE dishwasher?

The circuit for the water temperature sensor is not working. The control cannot read how hot the water is, so it stops the cycle rather than guess and risk a poor wash.

Is C7 related to C6?

No. C6 means the incoming water is too cool, while C7 means the temperature sensor circuit itself is not responding properly. A hot tap at the sink will not clear C7.

Is there an owner step for C7?

A breaker reset for about 30 seconds is the owner step. If C7 returns, the sensor or its wiring needs to be tested, and we do that on site before quoting any repair.

Book a visit

Still seeing C7?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545