Error code · Washer

GE UltraFresh Washer Code 24: Door Open and Locked at Once

Medium · inspection needed

Code: 24
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What 24 means

Code 24 on a GE UltraFresh front-load washer, the GFW510, GFW550, GFW650 and GFW850 series, means the control read an impossible door condition: the door looked both open and locked for five seconds in a row. Since both cannot be true, the control treats it as a door-circuit problem. Behind that behavior, the number is kept in the stored error history, which a technician reads, and these models can also show it on the display. You may see a cycle that will not begin, pauses, or a door that behaves inconsistently.

Common causes of 24

Door switch and lock switch signals that disagree
Door latch alignment
Wiring or connector in the door circuit
Control reading of the door inputs

✓ One safe check you can try

1. Open the door, remove anything caught in the opening, and close it until you hear it latch. 2. Look at the rubber seal for folds that can keep the door from seating. 3. If the washer still reports a door problem, stop using it and do not force the latch.

! Why to stop there

The conflicting door signals could come from the switch, the lock, the wiring or the control, and the number does not say which
We read the door circuit while opening and closing the door to see which signal is wrong
A written price is approved before work, and repairs include a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

70GE UltraFresh Washer Code 70: Inverter Start-Up Repeats 78GE UltraFresh Washer Code 78: Board Software Mismatch 85GE UltraFresh Washer Code 85: Voltage Out of Range Door / doorGE UltraFresh Washer Message "Door": Open the Door Before the Next Cycle LidGE Top-Load Washer Message "Lid": Open and Close the Lid to Continue Lid Locked light flashingGE Top-Load Washer Lid Locked Light Flashing: Three Cycles, No Lid Opened Fill light blinkingGE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid Wash and Rinse lights blinkingGE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering

2424 questions

Can a door really be open and locked?

No, which is why the control flags it. One of the door signals is wrong, and we find out which by testing the switch and lock readings.

Can a loose latch cause this?

A poorly seated door can give mixed readings, so we check the latch and strike first, then the circuit. If the code returns after a clean, firm close, the door circuit itself is what we test next.

Can I keep using it?

If the door will not lock reliably, we advise waiting for the check. It is better to wait for us than to run cycles with an unreliable door lock circuit.

Book a visit

Still seeing 24?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545