Error code · Washer

GE UltraFresh Washer Code 26: Final Spin Ended by Out-of-Balance Load

Medium · inspection needed

Code: 26
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What 26 means

On GE UltraFresh front-load washers, the GFW510, GFW550, GFW650 and GFW850 series, code 26 records that the control detected an out-of-balance load and could not bring the drum up to its final target spin speed. The washer then stops or shortens the final spin, leaving clothes wetter than usual. Readable from the stored error history by a technician, the number may also be shown on the display on these models. You may hear thumping or find a soggy load at the end of the cycle.

Common causes of 26

Bunched or oversized laundry
Washer not level or feet not firmly on the floor
Drum or suspension movement that lets the load shift
Speed feedback during the final spin

✓ One safe check you can try

1. Open the door, spread the wet laundry evenly and remove any single heavy item such as a rug or comforter. 2. Run a spin or rinse-and-spin cycle with a smaller, mixed load. 3. Push down on each top corner and make sure the washer does not rock.

! Why to stop there

If a small, balanced load still ends the spin early, the cause moves to the washer rather than the laundry
We check leveling, drum movement and the spin speed the control reaches
Repairs are priced in writing first and carry a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub CLrFLtrGE Compact Washer Message "CLrFLtr": Drain Pump Filter Needs Cleaning Load RebalancingGE Front-Load Washer Message "Load Rebalancing": Washer Is Correcting an Uneven Load A problem has been detectedGE Profile Harmony Washer Message "A problem has been detected with this unit": Electronics Alert 70GE UltraFresh Washer Code 70: Inverter Start-Up Repeats 78GE UltraFresh Washer Code 78: Board Software Mismatch

2626 questions

Why are my clothes still wet?

When the load is unbalanced, the control will not spin at full speed, so clothes can come out wetter. Redistributing the load usually tells us whether the washer itself is involved.

Is code 26 dangerous?

It is a protective stop, not a hazard, though violent shaking should be taken seriously and the washer stopped. It stops a spin that would shake the cabinet, so treat it as the washer protecting itself, while violent shaking means stop it right away.

Will the washer finish the cycle?

It usually ends or shortens the spin and moves on, leaving clothes damp, so you may need to rerun a spin with a better balanced load.

Book a visit

Still seeing 26?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545