Error code · Washer

GE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering

Medium · inspection needed

Code: Wash and Rinse lights blinking
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What Wash and Rinse lights blinking means

On the washer side of the GE unitized Spacemaker washer and dryer, models GUD24, GUD27 and GUV27, the Wash and Rinse lights blinking together tell you water is not entering the washer. The control reads this as a supply problem and starts a 4-minute lock-out before it will accept another start. You see the two lights blinking and the cycle stopped, often with the tub empty or only partly filled.

Common causes of Wash and Rinse lights blinking

House supply valves not fully open
Kinked or crushed fill hoses
Clogged inlet screens at the washer connection
Water inlet valve not passing water

✓ One safe check you can try

1. Check that one or both water supply valves behind the unit are turned fully on. 2. Look at the hoses for kinks. 3. Wait the 4 minutes. Unplugging restarts that timer, so leave it plugged in. 4. Begin the cycle again. 5. If the lights blink again, stop and let us look at the washer.

! Why to stop there

If water reaches the connections but the lights return, we check the inlet screens and the water inlet valve.
Low house water pressure can mimic this condition, and we can tell the difference on site.
The price is written before any work, with a 30-day workmanship warranty on the repair.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

LidGE Top-Load Washer Message "Lid": Open and Close the Lid to Continue Lid Locked light flashingGE Top-Load Washer Lid Locked Light Flashing: Three Cycles, No Lid Opened Fill light blinkingGE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub CLrFLtrGE Compact Washer Message "CLrFLtr": Drain Pump Filter Needs Cleaning Load RebalancingGE Front-Load Washer Message "Load Rebalancing": Washer Is Correcting an Uneven Load

Wash and Rinse lights blinkingWash and Rinse lights blinking questions

Why are the Wash and Rinse lights blinking on my GE Spacemaker?

The washer did not sense water entering. It treats that as a supply problem and locks the controls for four minutes. Check that the supply valves are on, wait, then restart the cycle.

Does unplugging the unit clear it faster?

No. Unplugging restarts the four-minute timer, so it takes longer. Leave the unit plugged in, let the timer finish, and then begin the cycle again.

Does this affect the dryer half?

No. This pattern describes the washer side only. The dryer half of the unitized unit has its own indicators and is not involved in this water-entry check.

Book a visit

Still seeing Wash and Rinse lights blinking?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545