Error code · Washer

GE Profile UltraFast Combo Code 353: softener residue in lint filter

Low risk · DIY check OK

Code: 353
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What 353 means

On GE Profile UltraFast combo washer-dryers such as the PFQ97HSPVDS, code 353 usually means the lint filter is clogged with fabric softener residue. The filter has a foam part and a mesh screen that catch lint during washing and drying. Softener leaves a sticky film that blocks them, so air and water move poorly. You may see longer drying, damp laundry or the 353 message on the display.

Common causes of 353

Fabric softener film on the foam filter and the mesh screen
Heavy lint buildup after many loads
Too much softener used per load

✓ One safe check you can try

1. Remove the filter and separate the foam filter from the mesh screen. 2. Rinse the foam in warm water. 3. Clean the mesh screen with a soft brush. 4. Reinstall both parts. 5. Run a wash and dry cycle to confirm the code is gone.

! Why to stop there

If 353 returns right after cleaning, the airflow or drain path beyond the filter may be restricted.
We check what lies past the filter before suggesting any part.
Using less softener keeps the filter cleaner, which is simpler than repeated repairs.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub CLrFLtrGE Compact Washer Message "CLrFLtr": Drain Pump Filter Needs Cleaning Load RebalancingGE Front-Load Washer Message "Load Rebalancing": Washer Is Correcting an Uneven Load A problem has been detectedGE Profile Harmony Washer Message "A problem has been detected with this unit": Electronics Alert 70GE UltraFresh Washer Code 70: Inverter Start-Up Repeats 78GE UltraFresh Washer Code 78: Board Software Mismatch

353353 questions

What does 353 mean on my combo washer-dryer?

It usually points to a lint filter clogged with fabric softener residue. The foam and mesh parts can be separated and washed, and doing that normally brings back normal airflow and normal drying times.

Can I use less softener to prevent it?

Yes. Softener leaves a sticky film that builds up and clogs the filter faster than lint alone does. Cutting back on softener, or using it less often, helps keep the filter clear between cleanings.

My filter is clean but 353 stays. Now what?

Something deeper may be restricting flow, such as the airflow or the drain path past the filter. We inspect that area and give you a written price before any repair begins.

Book a visit

Still unsure about 353?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545