Error code · Washer

GE UltraFresh Washer Code 35 to 64: Accelerometer Board Problem

Medium · inspection needed

Code: 35, 59, 60, 61, 63, 64
Appliance: Washer
Brand: GE
Warranty: 30-day workmanship

What 35, 59, 60, 61, 63, 64 means

The numbers 35, 59, 60, 61, 63 and 64 are accelerometer records on GE UltraFresh front-load washers (GFW510, GFW550, GFW650 and GFW850 series, 2020 and newer). The control sets them when the accelerometer board, which senses drum motion and imbalance, reports a problem. A technician reads them in the stored error history, and the display on these models may also show them. Owners may see unusual shaking, spin cycles cut short or a washer that limits its speed.

Common causes of 35, 59, 60, 61, 63, 64

Accelerometer board and its connector
Wiring between the sensor board and the main control
Mounting of the sensor to the cabinet
Main control reading of the sensor

✓ One safe check you can try

1. Level the washer so all four feet touch the floor and it does not rock. 2. Run a small, evenly spread load and see whether the spin behaves normally. 3. Leave the cabinet closed; the sensor board is not an owner repair.

! Why to stop there

A sensor board that reports a problem may be failing, loose or wrongly mounted, and the number alone does not decide
We check the board mounting and wiring, then test the signals the control receives
You see a written price before any part is replaced, with a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Fill light blinkingGE Top-Load Washer Fill Light Blinking: Two Blinks for No Water, Three for Open Lid Wash and Rinse lights blinkingGE Spacemaker Washer Wash and Rinse Lights Blinking: Water Not Entering Two furthest lights flashingGE Top-Load Washer Two Furthest Lights Flashing: General Cycle Error PoGE Top-Load Washer Message "Po": Slow to Pump Out the Water bALAnCINgGE Top-Load Washer Message "bALAnCINg": Load Is Uneven in the Tub CLrFLtrGE Compact Washer Message "CLrFLtr": Drain Pump Filter Needs Cleaning Load RebalancingGE Front-Load Washer Message "Load Rebalancing": Washer Is Correcting an Uneven Load A problem has been detectedGE Profile Harmony Washer Message "A problem has been detected with this unit": Electronics Alert

35, 59, 60, 61, 63, 6435, 59, 60, 61, 63, 64 questions

What does the accelerometer do?

It senses drum motion so the control can detect imbalance and limit spin. If it misreports, spins may be cut short or the washer may shake.

Is it the same as a bad load?

No. A bunched load is a laundry matter; these numbers point to the sensor board. The sensor reads motion, so a washer that is rocking on its feet can look like a sensor problem and is worth leveling first.

Does a shaking washer mean this code?

Not always. A washer that is out of level or has a bunched load shakes too. We rule those out before testing the sensor board.

Book a visit

Still seeing 35, 59, 60, 61, 63, 64?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 547-5545